AI-Assisted Urban Density Planning Through Integrated Environmental and Structural Simulation

Authors

  • Kirstie M. Lacey Department of Computer Science, University of Houston, Houston, TX, USA.; Tirza van der Laarse; Department of Computer Science, Colorado State University, Fort Collins, CO, USA. Author
  • Nakul Bawa School of Information Technology, University of Cincinnati, Cincinnati, OH, USA. Author

Keywords:

urban density; surrogate modeling; multi-objective optimization; building performance simulation; structural safety; solar access

Abstract

Urban density planning must reconcile land-use intensity with solar access, daylight, outdoor thermal conditions, and structural feasibility. Existing workflows often evaluate these dimensions sequentially or through simplified indicators, which obscures trade-offs and makes early-stage design search opaque. This manuscript develops a methodological framework for AI-assisted density planning that integrates environmental and structural simulation through spatially explicit decision variables, surrogate learning, constrained multi-objective optimization, and uncertainty-aware decision rules. The framework represents an urban block as a vector of height, footprint, spacing, and program variables; couples environmental and structural simulators through a common geometry and scenario interface; and replaces repeated high-fidelity calls with Gaussian-process surrogates trained through active learning. A constrained Pareto formulation links environmental penalties, structural demand and risk, construction cost, and solar availability. Robustness is introduced through expectation and conditional value-at-risk terms, while a transparent utility rule supports planner selection among nondominated plans. The contribution is not a trained model or a reporting of measured performance, but a coherent formulation that specifies inputs, simulation assumptions, learning architecture, constraints, and failure modes. The framework clarifies how AI can accelerate design-space exploration without displacing engineering checks or environmental evidence. It provides a basis for reproducible density studies, comparable surrogate diagnostics, and defensible early-stage planning decisions.

References

1. Ewing, R., & Cervero, R. (2010). Travel and the built environment: A meta-analysis. Journal of the American Planning Association, 76(3), 265–294.

2. Batty, M. (2013). The new science of cities. MIT Press.

3. Compagnon, R. (2004). Solar and daylight availability in the urban fabric. Energy and Buildings, 36(4), 321–328.

4. Robinson, D. (2006). Urban morphology and indicators of radiation availability. Solar Energy, 80(12), 1643–1648.

5. Sacks, R., Eastman, C., Lee, G., & Teicholz, P. (2018). BIM handbook: A guide to building information modeling for owners, designers, engineers, contractors, and facility managers (3rd ed.). Wiley.

6. Nguyen, A. T., Reiter, S., & Rigo, P. (2014). A review on simulation-based optimization methods applied to building performance analysis. Applied Energy, 113, 1043–1058.

7. Forrester, A. I. J., Sóbester, A., & Keane, A. J. (2008). Engineering design via surrogate modelling: A practical guide. Wiley.

8. Shahriari, B., Swersky, K., Wang, Z., Adams, R. P., & de Freitas, N. (2016). Taking the human out of the loop: A review of Bayesian optimization. Proceedings of the IEEE, 104(1), 148–175.

9. Deb, K., Pratap, A., Agarwal, S., & Meyarivan, T. (2002). A fast and elitist multiobjective genetic algorithm: NSGA-II. IEEE Transactions on Evolutionary Computation, 6(2), 182–197.

10. Zitzler, E., Thiele, L., Laumanns, M., Fonseca, C. M., & da Fonseca, V. G. (2003). Performance assessment of multiobjective optimizers: An analysis of issues and review. IEEE Transactions on Evolutionary Computation, 7(2), 117–132.

11. Saltelli, A., Ratto, M., Andres, T., Campolongo, F., Cariboni, J., Gatelli, D., Saisana, M., & Tarantola, S. (2008). Global sensitivity analysis: The primer. Wiley.

12. Kennedy, M. C., & O'Hagan, A. (2001). Bayesian calibration of computer models. Journal of the Royal Statistical Society: Series B (Statistical Methodology), 63(3), 425–464.

13. Goodchild, M. F. (2007). Citizens as sensors: The world of volunteered geography. GeoJournal, 69(4), 211–221.

14. Reinhart, C. F., & Cerezo Davila, C. (2016). Urban building energy modeling – A review of a nascent field. Building and Environment, 97, 196–202.

15. Kusiak, A., Tang, F., & Xu, G. (2011). Multi-objective optimization of HVAC system with an evolutionary computation algorithm. Energy, 36(5), 2440–2449.

16. Hong, T., Chou, S. K., & Bong, T. Y. (2000). Building simulation: An overview of developments and information sources. Building and Environment, 35(4), 347–361.

17. Tabasi, S. F., Luo, D., Rafizadeh, H. R., Le Nguyen, K., & Banihashemi, S. (2025). Generative optimization of building blocks for density, solar and structural performance. Journal of Building Engineering, 111, 113307.

18. Attia, S., Gratia, E., De Herde, A., & Hensen, J. L. M. (2012). Simulation-based decision support tool for early stages of zero-energy building design. Energy and Buildings, 49, 2–15.

19. Hensen, J. L. M., & Lamberts, R. (Eds.). (2011). Building performance simulation for design and operation. Spon Press.

20. Wetter, M. (2011). Co-simulation of building energy and control systems with the Functional Mock-up Interface standard. Journal of Building Performance Simulation, 4(2), 103–116.

21. Crawley, D. B., Hand, J. W., Kummert, M., & Griffith, B. T. (2008). Contrasting the capabilities of building energy performance simulation programs. Building and Environment, 43(4), 661–673.

22. Oke, T. R. (1988). Street design and urban canopy layer climate. Energy and Buildings, 11(1–3), 103–113.

Downloads

Published

2026-10-06